| Dante Audio Format | Dante/AES67 digital audio in/out, PCM 2-channel, 44.1kHz, 48kHz, 88.2kHz, 96kHz, 16/24-bit |
|---|
| Audio Latency | Dante device latency 5ms or 10ms, set in Dante Controller |
|---|
| Network Bandwidth | 100 Mbps Dante network |
|---|
| Input Sensitivity | +24dBu, +14dBu, +4dBu, 0dBV, -18dBV, -35dBV |
|---|
| Output Levels | +20dBu, +14dBu, +4dBu, 0dBV, -18dBV |
|---|
| Phantom Power | +48V on each input, switchable per input |
|---|
| DSP | Gain, 8-band PEQ on inputs and outputs (+/-15dB), output delay |
|---|
| PEQ Filter Types | Parametric, Lowpass, Highpass, Low Shelf, High Shelf |
|---|
| Frequency Response | 20Hz to 20kHz (+/-0.5dB) |
|---|
| THD+N | < 0.01% at +4dBu, 1kHz |
|---|
| S/N Ratio | at least 105dB at +4dBu, 1kHz, A-weighted |
|---|
| Dynamic Range | at least 105dB at +4dBu, 1kHz, A-weighted |
|---|
| Input Level | Max +24dBu (12.28Vrms) balanced line; max +18dBu (6.14Vrms) unbalanced line; min -35dBV (17.78mVrms) balanced mic |
|---|
| Input Impedance | 20k Ohm balanced; 10k Ohm unbalanced |
|---|
| Output Level | Max +20dBu (7.75Vrms) balanced; max +14dBu (3.875Vrms) unbalanced |
|---|
| Output Impedance | 600 Ohm balanced; 300 Ohm unbalanced |
|---|
| Mic/Line Inputs | 2x XLR/TRS combo, female; balanced/unbalanced |
|---|
| Line Outputs | 2x XLR, male; balanced/unbalanced |
|---|
| Dante Primary | 1x RJ45, locking; PoE+ PD (Class 4, IEEE 802.3at); Dante/AES67 audio, Web GUI, TCP/IP and RelayAV control |
|---|
| Dante Secondary | 1x RJ45, locking; PoE+ PD (Class 4, IEEE 802.3at); Dante/AES67 audio |
|---|
| Power Input | 1x DC 12V, 2-pin locking jack, max 1A |
|---|
| Ground | 1x chassis ground terminal |
|---|
| Transmission Distance | 328ft (100m) over CAT6/6A/7 |
|---|
| Methods | Built-in Web GUI, Dante Controller, ASCII API over TCP/IP; RelayAV |
|---|
| TCP/IP Control Port | 8000 (default), configurable |
|---|
| Presets | 5 preset scenes |
|---|
| IP Addressing | DHCP (default) or static, set separately for primary and secondary networks |
|---|
| Front Panel | Power LED, Status LED, Reset button (hold 5 seconds for KanexPro default settings) |
|---|
| ESD Protection | IEC 61000-4-2: +/-8kV (air-gap discharge), +/-4kV (contact discharge) |
|---|
| Power Supply | 12V/1A 2-pin locking power supply, or PoE+ PD (Class 4, IEEE 802.3at) |
|---|