Kanex Pro

• Extend HDMI signals up to 330 ft. (100m) on single CAT6 cable
• Supports Power over Ethernet from Tx or Rx
• 4K x 2K@30Hz Ultra HD resolutions 
• Infrared Signal Input/Output, embedded over extension
• Supports resolutions from 1080p/60@48bit
• High bandwidth up to 10.2 Gbps
• Enables 3D pass-through
• Supports CEC pass-through
• HDCP and EDID compliant
• Audio support: Dolby TrueHD & DTS Master Audio, 7.1 compliant
• Uncompressed audio support such as LPCM
• Front panel-LEDs for link activity and HDCP authentication
• Locking power suppy & HDMI connectors
• One external power supply 24V DC included

Note: Please adhere to the TIA/EIA568B standards when terminating network cables in the field.

Interface:

• Transmitter:
  • Input: HDMI
  • Output: HDBaseT (Cat 5e/6)
• Receiver:
  • Input: HDBaseT (Cat 5e/6)
  • Output: HDMI

Video Amplifier Bandwidth: 10.2 Gbps all channel 

Vertical Frequency Range: 50/60Hz

IR Carrier Frequency Range: 33-55kHz at 5 volts

Resolutions (HDTV): 480i, 576i, 480p, 576p, 720p, 1080i, 1080p, 4K /30Hz

Computer Resolution: WUXGA (1920x1200)

Transmission Distance & Resolutions:

• For 100 meters: up to 1080p @60Hz36bit, 3D1080p@30Hz36bit
• For 70 meters: up to 1080p @60Hz@48bit, 1080p @120Hz@24bit,                                                         3D 1080p@60Hz@36bit, 4K x 2K@30Hz@24bit

Power: 24V DC

Power Consumption: 9W (Maximum)

Regulatory Approvals Converter: FCC, CE, UL

Regulatory Approvals Power Supply: FCC, CE, UL

Dimensions: 3.93”x2.5”x1.0” (100x65x25.5mm)

Weight: 0.61lbs (0.28 Kg) x 2 (Tx and Rx)

Warranty: 3-Year limited

Helpful Tips & Recommendations:

• CAT-5 cables should not exceed 330 feet or (100m).
• Please adhere to the TIA/EIA568B standards when terminating network cables in the field.
• Shielded CAT5/6 with metal RJ-45 connectors are recommended to safeguard against random video flashes caused by electromagnetic interference (EMI).
• Do not use crossover cables, patch cables or Ethernet couplers to extend two CAT5 cables. This may damage the Tx & Rx.
• If the power LED indicator on the Tx/Rx unit is not on, check to make sure that the CAT5 cables are not crossed i.e., Ethernet to Link instead of Ethernet to Ethernet.